E.g. Event Control - Omron STC-MBS881POE Product Specifications And User's Manual

Event Control
10.18
The camera internal signal can be output as specified event information, like "exposure end", to PC used by
GVCP (GigE Vision Control Protocol).

e.g. Event control

Notified "Exposure End"
GenICam Parameters
Event Selector IEnumeration Type
Event Notification IEnumeration Type
STC-MBS881POE / STC-MCS881POE
Product Specifications and User's Guide
Event notification selection
Selection: "Action Late", "Frame Trigger", "Exposure Start", "Exposure End",
"Frame Start", "Frame End", "Block Discard",
"Line 0 Input Rising Edge", "Line 0 Input Falling Edge",
"Line 2 Input Rising Edge" and "Line 2 Input Falling Edge"
Event notification ON / OFF selection
On: Enable event notification
Off: Disable event notification
No.19S208-00
55/73