Table of Contents
Advertisement
1.3 PROTECTION AGAINST MECHANICAL HAZARDS
1.3.1
Risk of loss of stability
*7
Lifting eyes are provided on the engine. The secure and stable installation of engine is to
be carried out by the boat builder/installer.
1.3.2
Risk of break-up during
operation
*8
Instructions to indicate the type and frequency of inspections and maintenance required
for safety reasons are in the accompanying manual. The mounting, positioning and/or
guarding of parts where a risk of rupture or disintegration remains (in particular V-belts and
pulleys), are to be made compliant by the boat builder/installer.
1.3.3
Risks due to falling or
ejected objects
1.3.4
Risks due to surface
edges or angles
1.3.5
Risks related to
combined machinery
1.3.6
Risks related to
variations in operating
conditions
1.3.7
Risks related to
moving parts
1.3.8
Choice of protection
against risks arising
from moving parts
1.3.8.1
Moving transmission
parts
1.3.8.2
Moving parts involved
in the process
1.3.9
Risks of uncontrolled
movements
1.4 REQUIRED CHARACTERISTICS OF GUARDS AND PROTECTIVE DEVICES
1.4.1
General requirements
1.4.2.1
Fixed guards
1.4.2.2
Interlocking movable
guards
1.4.2.3
Adjustable guards
restricting access
1.4.3
Special requirements
for protective devices
1.5 RISKS DUE TO OTHER HAZARDS
1.5.1
Electricity supply
1.5.2
Static electricity
1.5.3
Energy supply other
than electricity
9
*
For the fuel filter, fuel injection pump, fuel injection nozzles, high pressure fuel injection
pipes and fuel hoses supplied and installed on the engine by Barrus. Any other fuel system
parts connected to the engine to be made compliant by the boat builder/installer.
1.5.4
Errors of fitting
1.5.5
Extreme temperatures
'Hot Surface' warning stickers are affixed to the rocker cover and/or the twin thermostat
*10
housing. All other protection or warnings to be made by the boat builder
1.5.6
Fire
1.5.7
Explosion
RDG603A81 – Issue 2
*7
*7
Yes
Yes
*8
*8
Yes
Yes
Not applicable
Yes
Yes
Not applicable
No
No
No
No
No
No
Not applicable
No
No
No
No
Not applicable
Not applicable
Not applicable
*9
*9
Yes
Yes
No
No
Yes
*10
Yes
*10
No
No
No
No
By boat builder/installer.
By boat builder/installer.
By boat builder
Guards to be specified and
fitted by the boat
builder/installer.
By boat builder/installer.
By boat builder
By boat builder
This concerns the fuel
injection system and gearbox
hydraulic system where fitted.
Fitting or refitting should only
be done by trained and skilled
personnel.
Protection or warnings to be
made by the boat builder
By boat builder
Page 73 of 93
Advertisement
Table of Contents
