Table of Contents
Advertisement
• Ensure that the anti-vibration mount centre screw is sufficiently raised so as not to
touch the engine bed. If this occurs, excessive engine vibration will be experienced
through the hull.
• For best results, fit the front AV mounts into the front holes in the engine rails. If the
engine room space is a problem the mounts can be fitted slightly further back in the
alternative holes and the front of the rail cut off – leaving 50mm of material to retain
strength (measuring from the centre of the mount hole to the front end of the rail).
Note: This procedure is only possible on non 'E' Kit engines and may result in a very
slight increase in vibration. AV mount installation points are shown on (Figure 11)
RDG603A81 – Issue 2
Figure 9: Correct Anti-Vibration Mount Installation
Page 22 of 93
Advertisement
Table of Contents
