Table of Contents
Advertisement
SECTION 11 – Fault Diagnosis
1. Failure Indicator Flashing Pattern
• If a fault occurs with the engine, the failure indicator light (Figure 23) will start flashing.
The sequence in which the failure indicator light starts to flash will indicate the fault
that has occurred.
• If a fault occurs with the engine, please contact your Shire Dealer.
When the engine is started the failure indicator light will always come on for
two seconds, whether or not any faults exist.
2. Examples Of Fault Code Light Sequences
• If an accelerator sensor failure is detected when the engine is started, the failure
indicator light will flash in a pattern of five (equal flashes) as shown in (Figure 24)
When the engine is started
ON
OFF
RDG603A81 – Issue 2
Figure 23: Failure Indicator Light
3s
2s
0.5s 0.5s
Figure 24: Accelerator Sensor Failure
Lower: 5 flashes
Failure Indictor Light
3s
Continuously ON
Page 60 of 93
Advertisement
Table of Contents
