Switching On The Projector And Computer - SMART Rear Projection Board 1800 Installation Manual

Switching on the Projector and Computer

1. Turn the on/off switch to the "on" position.
NOTE: The on/off switch is only available for cabinets in North America and Japan.
Elsewhere, power to the cabinet components is switched on and off via the power bar
located inside the cabinet.
All system components will be powered up, if you have previously switched on the
projector and computer. Some peripherals will need to be separately switched on each
time you power up the RPSB system.
2. Determine if the projector must be switched to rear-projection (reversed-image) mode or if
it can remain in front-projection mode by looking at the image. If the image is reversed
when you look at it from the front, switch the projector to rear-projection mode.
3. If your projector must be switched to rear-projection mode, use a remote control or the
appropriate button on the projector to switch it to that mode. Refer to your projector's
User's Manual for assistance.
RPSB 1800/1802 Installation Guide
31