Ballard Designs Lauren WS988 Manual

Ballard Designs Lauren WS988 Manual

Wall organizer

Advertisement

Customer Service: 800-367-2810
Online: www.ballarddesigns.com
PRODUCT NAME: Lauren Wall Organizer
ITEM NUMBER: WS988
ASSEMBLED DIMENSIONS : 9 1/2"H x 30"W x 11"D
PRODUCTS ARE NOT INTENDED
MADE IN CHINA
FOR COMMERCIAL USE.
UPDATED: 4-1-2020
Page 1 of 4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Lauren WS988 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Ballard Designs Lauren WS988

  • Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: Lauren Wall Organizer ITEM NUMBER: WS988 ASSEMBLED DIMENSIONS : 9 1/2”H x 30”W x 11”D PRODUCTS ARE NOT INTENDED MADE IN CHINA FOR COMMERCIAL USE. UPDATED: 4-1-2020 Page 1 of 4...
  • Page 2 Assemble in location for intended use. WARNING Falling Hazard Wall Decor is HEAVY and requires adequate support. Wall Brackets must be firmly attached to WALL STUDS. REQUIRED TOOLS: Phillips Screwdriver, Level, Pencil, Drill with 3/8” bit -Two person assembly suggested. Remove all parts, hardware and protective packaging from carton and carefully arrange on a clean,...
  • Page 3 STEP 1: Determine location for Oranizer and locate at least two WALL STUDS in wall behind it. Use a level to position Wall Bracket (D) and center a hole over each WALL STUD. Insert and drive Screw (A) directly into WALL STUD. For holes located in open drywall (no stud) use an Expansion Bolt (B). See Step 2 for installation instructions.
  • Page 4 STEP 3: Use a screwdriver to press down and firmly turn screw clockwise until it begins to slip indi- cating the barrel has crimped against inside of drywall. Back out and completely remove Screw, leaving bolt/anchor in wall. Position Bracket (D), align holes, replace and tighten Screw. Barrel Turn screw until it slips Remove screw...

Table of Contents