Advertisement
Table of Contents
- 1 Assemble in Location for Intended Use.
- 2 Required Tools
- 3 Note
- 4 STEP 1: Determine Location for Drying Rack.
- 5 STEP 2: for Bracket Hole Locations Where no Wall Stud Is Present.
- 6 STEP 3: Use a Screwdriver to Press down and Firmly Turn Screw.
- 7 STEP 4: with Bracket (D) Firmly Attached to Wall.
- 8 Cleaning & Care
- Download this manual
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Ballard Designs WS996
Summary of Contents for Ballard Designs WS996
- Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: Mini Beadboard Drying Rack ITEM NUMBER: WS996 ASSEMBLED DIMENSIONS : 7 1/4”H x 23”W x 2 1/2”D PRODUCTS ARE NOT INTENDED MADE IN CHINA FOR COMMERCIAL USE. UPDATED: 4-1-2020 Page 1 of 4...
- Page 2 Assemble in location for intended use. WARNING Falling Hazard Wall Decor is HEAVY and requires adequate support. Wall Brackets must be firmly attached to WALL STUDS. REQUIRED TOOLS: Phillips Screwdriver, Level, Pencil, Drill with 3/8” bit -Two person assembly suggested. Remove all parts, hardware and protective packaging from carton and carefully arrange on a clean,...
- Page 3 STEP 1: Determine location for Drying Rack and locate at least two WALL STUDS in wall behind it. Use a level to position Wall Bracket (D) and center a hole over each WALL STUD. Insert and drive Screw (A) directly into WALL STUD. For holes located in open drywall (no stud) use an Expansion Bolt (B).
- Page 4 STEP 3: Use a screwdriver to press down and firmly turn screw clockwise until it begins to slip indi- cating the barrel has crimped against inside of drywall. Back out and completely remove Screw, leaving bolt/anchor in wall. Position Bracket (D), align holes, replace and tighten Screw. Barrel Turn screw until it slips Remove screw...
Need help?
Do you have a question about the WS996 and is the answer not in the manual?
Questions and answers