Configuring The Network (Optional) And Remote Service - Siemens ARCADIS Varic Start-Up Instructions

Specific system settings
•
Switch on the system and wait for the system to boot.
NOTE

Configuring the network (optional) and remote service

•
Configure the network according to the Configuration Guide,
SPR2-310.843.01.01.xx.xx and the remote connection according to Installation, Sie-
mens Remote Service, SP00-000.816.02.01.xx.xx.
NOTE
Siemens AG
Medical Solutions
With the introduction of the Hibernation Mode, system configura-
tion changes are not applied if the system is switched off and then
switched on again using the power buttons on the monitor cart.
To correctly apply the modified data, perform a system shutdown.
Open the <Options> - <End Session> menu and click the "Shut-
down system" button. Immediately thereafter, press the Power off
button on the monitor cart.
The system shuts down and switches off automatically.
With the introduction of the Hibernation Mode, system configura-
tion changes are not applied if the system is switched off and
then switched on again using the power buttons on the monitor
cart.
To correctly apply the modified data, perform a system shutdown.
Open the <Options> - <End Session> menu and click the "Shut-
down system" button. Immediately thereafter, press the Power off
button on the monitor cart.
The system shuts down and switches off automatically.
SPR2-310.815.01.07.02
12.06
Page 39 of 64
CS PS SP
39
0
ARCADIS Varic