Advertisement
Ending Session
1. Set magnification to 4000× (MAG/CAML knob (right console))
2. Spread beam (BRIGHTNESS knob (left console)) to cover approximately half of the
screen, center beam if uncentered (SHIFT knobs, X and Y, on the left and right consoles).
3. Turn off filament. Use 'beam controller' window. Press Filament OFF button.
4. Record the time off in the log book.
5. Remove specimen (follow instructions above)
6. Insert empty holder back into microscope (follow instructions above).
7. Close AMT camera program.
8. Turn off monitors and lights.
EM Suite 15/11/2016
P a g e
12 | 14
Advertisement
