Download Print this page

JEOL JFC-1100 User Instructions

Fine coat ion sputter

Download this manual

Jeol Fine Coat Ion Sputter JFC-1100

User instructions

Operation of this equipment is restricted to trained personnel familiar with the user

instructions, general safety precautions, and laboratory rules. Contact the laboratory

manager or your supervisor/group leader to get permission to use this equipment.

Chamber

Voltmeter

Ammeter

Updated | Oppdatert 10.07.2018

Page 1 Jeol Fine Coat Ion Sputter JFC-1100 User instructions Operation of this equipment is restricted to trained personnel familiar with the user instructions, general safety precautions, and laboratory rules. Contact the laboratory manager or your supervisor/group leader to get permission to use this equipment.
Page 2 Routine sample coating Use gloves to handle the samples in order to avoid contamination of your sample and of the chamber. 1. Connect the power cord to the electricity plug. 2. Open the chamber and place the sample(s) on the sample holder (Fig.1). Fig.
Page 4 Experimental Conditions For the preparation/coating of conodont specimens, the coating conditions are as follows:  Voltage: 1200 V (5–10 mA) and coating time of 4 min  Process is stopped and stubs are rotated by ~90°  Continue coating for 4 min In case of severe charging of conodont specimens, the following coating conditions have been followed: ...