Table of Contents
Advertisement
2. Drag audio inputs from "Signal List"to audio outputs as
shown in the right figure;You can also drag a new audio input
to replace the previous one.
The relation between audio input and output is unique;
3. Click left mouse to adjust the volume in "volume
bar"shown in the audio output.
Layer
Layer number: Numbers in the corner is to show how many
layers at present allowed to put in the output.
A 2K signal occupies one layer, and a 4K2K60 signal occupies
four layers
The number in the red rectangle on the right figure represents
the number of layers that can be placed at the output.
Layer Adjustment
there are two ways to adjust layer.
1. Use the bar under the interface
Choose one layer and the bar shows its signal source, type in
position and size.click Set to confirm.
2. Layer Scale and Crop
Choose one layer needed to be adjusted,and type in its
position and size.
this icon means data related, when width is changed,
height will be changed as same proportion.
this icon means data not related, width and height need to
be filled respectively.
© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 592 5771197 |
support@rgblink.com
|
www.rgblink.com
22 / 30
Advertisement
Table of Contents
