Preset Selection - Clarion compact disc Owner's Manual

4) When a desirable station is tuned in, press
the SHIFT button
22
and press the preset button to which the sta-
tion is to be stored.
The preset scanning is canceled and you can
*
listen to the station.

Preset selection

1) Press the BND button
2) Press one of the Preset buttons
select the stored station.
Note:
• In PS/AS mode, do not perform the preset selec-
tion (excluding the preset scanning).
In PS/AS mode, when the Preset button
pressed, the auto storing starts and all the stored
stations are cleared.
ISR memory
If an AM or FM station is stored in the ISR but-
ton, it can be directly tuned in by pressing the
ISR button from any other mode.
1) Press the BND button
2) Press the Preset buttons
button to tune in to a station you want to
11
store.
3) Press and hold the ISR button
seconds.
When a beep sounds, the display turns to the
ISR (Instant Station Recall) display and the
frequency is stored.
4) Press the ISR button
vious mode.
Calling the station with the ISR button
1) In any mode, pressing the ISR button
allows you to tune in to the stored station.
When the ISR is functioning, the ISR display
*
appears.
The default ISR setting is 87.9 MHz.
*
18
to cancel PS/AS mode
13 to select a band.
to to
16 21
is
17
to select a band.
13
to or the ENT
16 21
for about 2
24
to return to the pre-
24
24
2) To cancel the ISR function, press the ISR but-
ton or FUNC button
24
is canceled and the previous mode returns.
Area change
When you listen to the radio outside the U.S.,
use this function.
Switchable frequency setting
This car stereo is initially set to tune in frequen-
cy intervals of 10 kHz for AM and 200 kHz for
FM, the standard calibrations in the U.S. When
using the unit outside the U.S., use the following
procedure to switch the frequency range.
The table below lists the frequency specifica-
tions for the U.S. and other countries.
Initial Setting
(U.S. standard)
Frequency
10 kHz
spacing
AM
Frequency
530 to 1710 kHz
range
Frequency
200 kHz
spacing
FM
Frequency
87.9 to 107.9 MHz
range
Changing area
Depending on whether you use the unit in the
U.S. or outside the U.S., switch the area as fol-
lows:
1) Press the ADJ button
FIGURATION display.
2) Slide the Up/Down button
(down) and move the cursor to "AREA."
3) Slide the Up/Down button
switch the area (between in the U.S. and out-
side the U.S.).
4) Press the ADJ button
vious mode.
The new setting returns to the initial setting.
*
. The ISR function
12
New Setting
(outside U.S.)
9 kHz
531 to 1629 kHz
50 kHz
87.5 to 108 MHz
to go to the CON-
10
to (up) or
11
to (right) to
11
10 to return to the pre-