Bosch MSGP3L User Manual page 16

en Cleaning the device
¡ You can descale the appliance either us-
ing lemon juice or specially developed
descaling tablets.
Requirements
¡ There are no plant capsules in the plant
tray.
¡ The device is fully assembled, a height
module is inserted and the light unit fit-
ted.
Prepare the descaling solution. Select
1.
one of the following options:
Dissolve two teaspoons of citric acid
‒
in 1 litre of warm water at approx.
50 °C.
Dissolve a descaling tablet in 1 litre of
‒
lukewarm water and wait 5 minutes.
Slowly pour the prepared descaling solu-
2.
tion into the plant tray.
Touch the touch button for 15 seconds
3.
until the light unit lights up green.
25
→ Fig.
a The pump will run for approx. 3 minutes.
Notes
¡ If not all deposits have dissolved, leave
the descaling solution to work for at least
2 hours and then start the pump again.
¡ If necessary, leave the descaling solution
to work in the bowl overnight.
Ordering descaling tablets
Order descaling tablets from customer ser-
vice.
Quantity
6 x 18 g
12 x 18 g
Cleaning the device
After descaling, clean all parts thoroughly.
→ Fig. 26 - 30
Notes
¡ Clean all parts as indicated in the clean-
ing overview.
¡ After drying re-assemble all parts in re-
verse order.
16
Order number
311864
311893
¡ When inserting the pump impeller, check
that there are no residues on or under-
neath the impeller. The pump impeller
must turn easily.
Overview of cleaning
31
→ Fig.
Troubleshooting
Light unit will light up continuously red
until the water bowl is removed.
The pump is blocked or the impeller is
missing.
Check that the pump impeller is posi-
1.
tioned correctly.
2. Check that the pump housing is posi-
tioned correctly.
The device is standing on a magnetic metal
surface.
Check whether the location is suitable in
1.
the long term.
→ "General information", Page 14
Select a different location.
2.
Light unit does not light up.
Device is not connected to the power
supply.
Check whether the power supply is
1.
plugged into a socket.
Check whether the connecting cable is
2.
properly connected to the docking unit.
Ambient temperature above 40 °C. The
overtemperature protection has switched
the device off.
Check whether the location is suitable in
1.
the long term.
→ "General information", Page 14
Close curtains or blinds to lower the
2.
room temperature.
Sleep mode is switched on or lighting has
been switched off manually.
→ "Setting sleep mode", Page 15
1.
→ "Dimming or switching off the lighting
2.
temporarily", Page 15
Printed on 100% recycled paper