U-Line UCDE215 User Manual & Service Manual page 16

USER GUIDE
Connecting External Nitrogen
Source
Note: Connection to an external Nitrogen source
requires drilling one hole through the pre-
installed bulkhead located near the top of the
back wall.
Install Infuser Regulator
1. Align infuser regulator with pre-drilled holes in upper
left corner of side wall. Use 2 screws to attach.
Interior
Side Wall
Connects
to keg
Prepare bulkhead and back panel
1. Inside the cabinet, drill out 1 of the
bulkhead.
2. Insert gasket ring into drilled-out hole.
3. In the back of the unit, remove back panel.
General Installation
To Tap Tower
⁹⁄16
" holes in the
4. Insert gasket ring into hole that corresponds to the
drilled-out hole in bulkhead.
5. Inside cabinet, apply foodgrade lubricant to inside
of gasket ring in bulkhead and push nitrogen hose
through.
Inside
6. Attach nitrogen hose to infuser regulator
T-Connector
7. At the back of the unit, appy foodgrade lubricant to
inside of gasket ring and push nitrogen hose through.
8. Re-install back panel.
Outside
9. Connect nitrogen hose to external nitrogen source.
10. Continue with inside connections (see CONNECT
NITROGREN TO KEG in this manual)
16
u-line.com
Connects to
external nitrogen