Table of Contents
Advertisement
EN
9.7
ASSEMBLE THE TRIMMER HEAD
1. Put the trimmer head onto the housing.
2. Install the nut.
3. Put the metal rod in the specified angle transmission
hole to fix the trimmer head.
4. Tighten the nut on the trimmer head
counterclockwise with a wrench.
You must install the cut-off blade when you use the
trimmer head.
9.8
REMOVE THE BRUSH CUTTER
Apply the guard to the blade.
1. Put the meatal rod (F) in the specified angle
transmission hole (D) to fix the trimmer head.
2. Loosen the nut (J) clockwise and remove the outer
cup (I).
3. Remove the plate (H) and brush-cutter blade.
4. Remove the inner cup (F).
J
D
E
IMPORTANT
WARNING
J
English
9.9
ASSEMBLE THE BRUSH CUTTER
Wear gloves and be careful with sharp edges.
22
Apply the guard to the blade.
Use the specified Nylon locknut which is packed with
the blade, to assemble the blade.
You must change the locknut after you use it for 20
times.
1. Put the metal rod (E) in the specified angle
transmission hole (D) to fix the trimmer head.
2. Put the inner cup (F) onto the center shaft.
3. Put the brush-cutter blade (12) on top of the inner
cup. Make sure the blade is in the center.
4. Put the plate (H) above the blade.
5. Put the outer cup above the plate (I).
6. Put the locknut above the outer cup.
7. Tighten the lock-nut (J) counter-clockwise to 44-58"
N.M of torque with a 19mm wrench.
10
TRANSPORTATION AND
STORAGE
10.1 MOVE THE MACHINE
When you move the machine, you must:
•
Wear gloves.
•
Stop the machine.
•
Remove the battery pack and charge it.
•
Assemble the blade guard.
10.2 STORE THE MACHINE
•
Remove the battery pack from the machine.
•
Make sure that children cannot come near the
machine.
12
•
Keep the machine away from corrosive agents such
as garden chemicals and de-icing salts.
•
Secure the machine during transportion to prevent
D
damage or injury. Clean and examine the machine
for any damage.
10
WARNING
WARNING
WARNING
WARNING
Advertisement
Table of Contents
