Table of Contents
Advertisement
Available languages
Available languages
EN
4.9
ADJUST THE CUTTING DIAMETER
Figure 10.
The machine is set at a 35.6 cm cutting diameter. You
can adjust to a 40.6 cm cutting diameter.
Set the cutting diameter to 35.6 cm for greater runtime
and 40.6 cmfor a larger cutting area.
1. Remove the battery pack.
2. Remove the blade screws from the cut-off blade.
3. Turn the cut-off blade 180°.
4. Tighten the blade screws.
4.10 USE THE SHOULDER STRAP
Figure 11.
1. Attach the carabiner to the carrying ring on the pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about the width of a hand below your right hip.
5
MAINTENANCE
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or
do the maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight.
Check regularly that the handles are firmly mounted.
Use only the replacement parts and accessories of the
initial manufacturer.
5.1
GENERAL INFORMATION
Only your dealer or approved service center can do
the maintenance that is not given in this manual.
Before the maintenance operations:
•
Stop the machine.
•
Remove the battery pack.
•
Cool the motor.
•
Use correct clothing, protective gloves, and safety
glasses.
NOTE
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
English
5.2
CLEAN THE MACHINE
•
Clean the machine after each use with a moist cloth
dipped in neutral detergent.
•
Do not use aggressive detergents or solvents like
"glass cleaner" to clean the plastic parts or handles.
•
Keep the trimmer head free from grass, leaves, or
excessive grease.
•
Keep the air vents clean and free of debris to avoid
overheating and damage of the motor.
•
Do not spray water onto the motor and electrical
components.
5.3
REMOVE ANY REMAINING LINE
Figure 12 - 15.
1. Simultaneously press the tabs on the sides of the
trimmer head.
2. Remove the spool cover and the spool.
3. Remove any remaining line.
4. Put the spool into the spool housing.
5. Install the spool cover onto the trimmer head.
6. Push the spool cover until it clicks into position.
5.4
INSTALL THE CUTTING LINE
Figure 16-18.
Do not put more than 15 feet of cutting line in at a
time.
1. Line up the slots on the spool cap with the slots on
the trimmer head.
2. Put the cutting line through the hole. Push the
cutting line until it exits the opposite hole.
3. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
4. Turn the spool cap clock-wise to wind the cutting
line into the trimmer head. Keep approximately 5 in
of cutting line above out of each side of the trimmer
head.
5.5
REMOVE THE TRIMMER HEAD
Figure 19- 20.
1. Put the metal rod in the specified angle transmission
hole to fix the trimmer head.
2. Turn the trimmer head clockwise to loosen it. Do not
remove the spacer from the shaft.
5.6
ASSEMBLE THE TRIMMER HEAD
Figure 21.
1. Put the metal rod in the specified angle transmission
hole to fix the trimmer head.
6
NOTE
Advertisement
Chapters
Table of Contents
