Replace The Bump Knob; Assemble The Trimmer Head; Remove The Trimmer Head; Transportation And Storage - GreenWorks 48T16 Operator's Manual

5. Do not wind the lines beyond the edge of the spool.
10.5

REPLACE THE BUMP KNOB

1. Push the tabs on the sides of the trimmer head at the same
time.
2. Pull and remove the spool cover.
3. Remove the spool.
4. Hold the bump knob (23) and pry it out with a metal rod
(not provided).
5. Put the new bump knob into the spool housing (24).
10.6

ASSEMBLE THE TRIMMER HEAD

1. Put the metal rod (25) in the specified angle transmission
hole to fix the trimmer head.
English
2. Assemble the trimmer head.
3. Turn the trimmer head counterclockwise to tighten it.
4. Remove the metal rod.
You must install the cut-off blade when you use the trimmer
head.
10.7

REMOVE THE TRIMMER HEAD

1. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
2. Turn the trimmer head clockwise to loosen it. Do not
remove the spacer from the shaft.
11 TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
tranportation and storage.
11.1

STORE THE MACHINE

• Remove the battery pack from the machine.
• Make sure that children cannot come near the machine.
• Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine for any
damage.
11
IMPORTANT
WARNING
EN