Remove The Guard; Remove The Trimmer Head; Assemble The Trimmer Head; Attach The Brush Cutter Guard - GreenWorks 82TB20 Operator's Manual

10.5

REMOVE THE GUARD

1. Remove the screws from the trimmer head with the
supplied torx wrench.
2. Remove the guard.
10.6

REMOVE THE TRIMMER HEAD

1. Put the metal rod (18) in the motor housing hole (19) to
fix the trimmer head.
2. Remove the spool cover and spool.
3. Loosen the nut (20) on the trimmer head clockwise with a
wrench (21).
4. Remove the trimmer head (10).
10.7

ASSEMBLE THE TRIMMER HEAD

1. Put the trimmer head onto the housing.
2. Install the nut.
3. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
4. Tighten the nut on the trimmer head counterclockwise
with a wrench.
English
21
20
19
18
20
10
IMPORTANT
You must install the cut-off blade when you use the trimmer
head.
10.8 ATTACH THE BRUSH CUTTER
GUARD
IMPORTANT
The brush cutter is used to cut dense grass, hard weeds,
light brushes and other similar vegetation at or around
ground level. The cutting plane must be approximately
parallel to the ground surface. You cannot use the machine
to cut or chop hedges, shrubs, bushes, flowers and compost.
You have to assemble the brush cutter guard before

assemble the brush cutter.

1. Put the brush cutter guard onto the trimmer head.
2. Align the screw holes on the guard with the screw holes
on the trimmer head.
3. Tighten the screws with the supplied hex wrench.
10.9 ASSEMBLE THE BRUSH CUTTER
Wear gloves and be careful with sharp edges.
Apply the guard to the blade.
1. Put the meatal rod (18) in the motor housing hole (19) to
fix the trimmer head.
2. Put the brush-cutter blade (22) on top of the gear box
(23). Make sure the blade is in the center.
3. Put the plate (24) above the blade.
4. Put the outer cup (25) above the plate.
5. Put the lock-nut (26) above the outer cup.
13
WARNING
WARNING
WARNING
EN