Configuring Ethernet And Ip; Ethernet And Ip Settings Page; Ip Settings Changed Confirmation - Proconx GCP-MG User Manual

Configuring Ethernet and IP

Select the Configuration→Ethernet & IP sub-menu from the menu bar to open
the Ethernet and IP settings which are shown below:
Figure 5.6: Ethernet and IP settings page
The following Ethernet parameters are shown:
MAC address
The device' unique MAC address. This number is hard coded and cannot be changed.
The following Internet protocol (IP) settings can be entered:
IP address
The IP address assigned to this device.
Subnet mask (also known as indexterm2:[network mask])
If you have a router, enter the subnet mask for the segment to which this device is
attached.
Gateway address
If your network segment has a router, enter its IP address here. Otherwise leave the
address as 0.0.0.0.
Once you click Save the new settings are stored and applied instantly. The new settings
are confirmed with the following page:
Figure 5.7: IP settings changed confirmation
Please write down the new IP address so you are able to communicate with the
device in the future!
UMGCPMG-2201
Web browser based management
27