Table of Contents
Advertisement
Hardware version
MBDC-200 hardware version.
Firmware version
The firmware version that is installed on the MBDC-200.
Serial number
The serial number of the MBDC-200. The serial number is specific to your device.
Configuring and commissioning
The configuration pages are accessed by clicking on the Configuration... menu entry
on the menu bar which then expands a configuration sub-menu. All configuration
settings are kept in the device' non-volatile memory.
If you make changes to any settings, remember to save each page before changing
to a different page!
Configuring Ethernet and IP
Select the Configuration→Ethernet & IP sub-menu from the menu bar to open
the Ethernet and IP settings which are shown below:
Figure 5.5: Ethernet and IP settings page
The following Ethernet parameters are shown:
MAC address
The device' unique MAC address. This number is hard coded and cannot be changed.
The following Internet protocol (IP) settings can be entered:
IP address
The IP address assigned to this device.
UMMBDC200-2201
Web browser based management
19
Advertisement
Table of Contents
