Table of Contents
Advertisement
Use the menu bar shown on the left side to navigate the different pages.
In order to connect to the GCP-MG via TCP/IP, your PC must be on same IP subnet
as the gateway. In most situations this means that the first three numbers of the
IP address have to be identical.
Monitoring and diagnostic
The GCP-MG offers several web pages which allow monitoring of the status of the
different communication networks and the device performance.
Device status
The Overview page shows the principal device status as shown in the following picture:
Figure 5.2: Overview page
The value shown in the Device row represents the device status register which keeps
track of run-time faults. All run-time faults are latched and must be reset by the user.
The following faults can be listed here:
OK
The device is fault free.
Watchdog reset
This warning indicates that the device was reset by it's internal watchdog supervision
circuit.
Brown out reset
This warning indicates that the device was reset by it's internal supply voltage
monitoring circuit. This fault occurs when the supply voltage drops below the lower
limit.
Device out of memory
This warning indicates that the internal dynamic memory has been exhausted and
due to this a certain function could not be completed.
22
UMGCPMG-2201
Advertisement
Table of Contents
