Applications Of Use; Media Recommendations - Intermec EasyCoder PM4i User Manual

Applications of Use

The RFID Kit (Gen 2, 869/915 MHz) is an optional device for the
EasyCoder PM4i that provides the printer with capacity to read and write to
RFID tags.
The internal RFID radio module operates on the UHF band at 869 or 915
MHz depending on region.
The RFID interface board occupies one of the slots for optional interfaces
at the back of the printer and features an extra RS-232 serial interface.
For printers running Fingerprint, this is referred to as "uart2:", "uart3:" or
"uart4:" depending on which slot is used and what other optional devices are
installed. Please note that the 9-pin connector is not functional when the
board is installed in an IPL printer.
Your printer should be fitted with either Intermec Fingerprint v8.70.0 (or
later) or IPL v2.70.0 (or later), or RFID functionality cannot be guaranteed.

Media Recommendations

To ensure complete functionality of the EasyCoder PM4i equipped
with an RFID Kit (Gen 2, 869/915 MHz), we strongly urge you to use
Intermec recommended RFID media only. Printers with factory-installed
RFID kits come with a sample roll of 4x6" RFID media.
General media recommendations and order information is provided
through an Intermec web page: go to www.intermec.com. Choose
Products > RFID, and then click Tags, Inserts and Smart Labels.
RFID Kit (Gen 2, 869/915 MHz) User's Guide
The RFID Kit (Gen 2, 869 MHz) uses an EPCglobal
Gen 2-certified IM5 Module (86X MHz RFID
frequency band).
The RFID Kit (Gen 2, 915 MHz) uses an EPCglobal
Gen 2-certified IM5 Module (915 MHz RFID
frequency band).