Intermec EasyCoder PM4i User Manual page 19

- Fingerprint users: run a TESTFEED, either via the console
(Shift+Feed) or the printer's home page. On IPL printers, the
media is identified automatically when you lower the printhead
and press the FEED key.
• The output power to the antenna could need adjusting.
- Check the recommended field strength for your specific media
(see "Media Recommendations"). Adjust the parameter
accordingly.
Problem:
None of the RFID commands work. The message "RFID inactive" is
displayed.
Possible Causes and Suggested Remedies:
• RFID Mode has been disabled.
- Enable it with the following commands:
SETUP "RFID,MODE,ENABLE"
<SI>J1
Problem:
Printing on non-RFID media is slow and printing is halted in between
labels.
Possible Causes and Suggested Remedies:
• RFID mode is enabled.
- Disable it with the following commands:
SETUP "RFID,DISABLE"
<SI>J0
Problem:
After the printer has been loaded with a new roll of RFID media, it is
unable to write to the tags.
Possible Causes and Suggested Remedies:
• The printer has not yet identified the RFID media type.
- If RFID media is changed without the printer having been
RFID Kit (Gen 2, 869/915 MHz) User's Guide
(Fingerprint)
(IPL)
(Fingerprint)
(IPL)
1