are allowed. To ensure the media is not retracted past the printhead, the
maximum backward motion is restricted electronically.
Note: For 4x3" and 4x6" labels you will be required to change
the Tagadjust variable. Set Tagadjust to +112 (for printhead
resolution 203 dots/inch) or +166 (for printhead resolution
300 dots/inch). Be sure to check the recommendations for
your RFID media, as these values may vary slightly between
different types of media.
RFID,FIELDSTRENGTH
This parameter (a value between 0 and 100) indicates the level of
the field strength that the antenna applies in order to communicate
with the RFID tag. By default, this is set to the maximum value. You
should not change this parameter unless it is explicitly stated in the
recommendations for your RFID media.
Changing the Setup
RFID setup values are changed with the following commands:
<SI>Jn,m,p
<SI>Kn
10
where n: is 1 for RFID,MODE,ENABLE and 0 for
RFID,MODE,DISABLE
m: TAGADJUST value in dots.
p: number of RETRIES.
where n: is the VOIDTEXT string.
RFID Kit (Gen 2, 869/915 MHz) User's Guide