Chapter 3 — Fingerprint Control
Activating the Cutter
The cutter is activated by CUT or CUT ON statements, see the Intermec
Fingerprint v8.xx, or the Intermec Direct Protocol v8.xx manuals. Applica-
tion programs may have related facilities for operating the cutter.
Controlling the Cut Position
The edge will cut through the media approx. 33 mm (1.3 inches) in
front of the printer's dot line. The relation between the media and the
actual cutting position is controlled by the Feed Adjustment parameters
in the Setup Mode or in setup fi les or setup strings.
The following feed adjustment values are recommended for cutting:
Type of Cutting
Cut between labels w. gaps
Start adjust:
Stop adjust:
Cut fi x and variable length strip (no liner!)
Start adjust:
Stop adjust:
Cut variable length strip (no liner!)
Start adjust:
Stop adjust:
8
8 dots/mm printhead
- 325 dots
+ 240 dots
- 250 dots
+ 160 dots
- 340 dots
+ 340 dots
Cutter Kit (EasyCoder PF4i-series) Installation Instructions
11.81 dots/mm printhead
- 480 dots
+ 354 dots
-369 dots
+236 dots
- 502 dots
+ 502 dots