Intermec EasyCoder 101 User Manual page 60

1. Remove the Ethernet cable from the AXIS Ethernet adapter.
2. Turn off the Ethernet adapter.
If the Ethernet adapter uses a power supply, disconnect the power supply from
the electrical source.
If no power supply is required by the Ethernet adapter, turn off the printer.
3. Press and hold the AXIS adapter test button. While pressing the test button, turn on
the AXIS adapter by turning on the printer or reconnecting the power supply cord.
Keep the test button pressed for at least 5 seconds after restoring power or until the
Network LED flashes 5 times at 1 second intervals.
4. Release the test button and wait for 5 LED flashes.
5. Press and hold the test button again until the Network LED remains constantly lit.
6. Turn off the AXIS adapter.
7. Reinstall the Ethernet cable to the AXIS adapter.
8. Restart the AXIS adapter by turning it on. The AXIS adapter is now reset to factory
default settings.