Intermec EasyCoder 101 User Manual page 14

a. If you have an external AXIS Ethernet adapter that is connected to a power
supply, disconnect the power supply from the power source (electrical outlet or
power strip) and reconnect it.
b. If you have an internal AXIS Ethernet adapter or an external AXIS Ethernet
adapter that receives its power from the printer (requires no power supply), use
the printer on/off switch to cycle power.
3. The AXIS IP Installer will detect the printer on the network and the serial number
of the AXIS Ethernet adapter will be listed in box 1.
4. Select the device in box 1, then type the IP address in box 2. Click the Set IP
address box.
5. When prompted, launch the IP Installer web browser to display the AXIS Ethernet
adapter home page.
6. Click the configuration tab. Disable DHCP, BOOTP, RARP, and WINS by clicking
on the configuration button, and then selecting NO on these items.
7. Click Submit to activate the changes.
Note: If this method is not successful, reset the AXIS Ethernet adapter to factory default
and repeat the procedure. For help, see the "Resetting the AXIS Ethernet Adapter to
Factory Default" procedure in the Appendix.
You are now ready to add your EasyCoder printer to Microsoft Windows. To add a
printer to Windows 95 or 98, see Chapter 2, or to add a printer to Windows NT, see
Chapter 3.
This method can be used to assign an IP address to either an IPL printer or a DP printer.
If you prefer, you can assign an IP address to a DP printer using the keys on the printer's
front panel. See your printer user's manual for instructions.
1. Start a DOS window.
2. At the DOS prompt, type the following commands:
arp -s nnn.nnn.n.nnn nn-nn-nn-nn-nn-nn
ping nnn.nnn.n.nnn
arp -d nnn.nnn.n.nnn
Where:
nnn.nnn.n.nnn
nn-nn-nn-nn-nn-nn
is the IP address for the Ethernet adapter.
is the Ethernet address (or MAC) for the
Ethernet adapter; located on the adapter
on the back of the printer.