Table of Contents
Advertisement
To test the connection with a firmware version lower than 5.59
Note: Data Line Print mode is available on the following printer
models: 3240, 3400, 3440, 3600, 4400, 4420, and 4440.
1. Turn off your printer.
2. Press and hold the Feed/Pause button while you turn on the printer.
The printer prints the hardware configuration test label.
3. Release the Feed/Pause button. The printer is now in Data Line
Print mode.
4. Press and release the Test button on the Ethernet adapter. The
printer prints each character with its hexadecimal equivalent
underneath.
5. To enter normal Print mode, turn the printer power off and then on
again.
Downloading the IP Address
This section explains how to use ARP (address resolution protocol) to
download the IP address to the Ethernet adapter. For other methods of
downloading the IP address, see the Intermec Ethernet Adapter User's
Manual (Part No. 068749).
Note: Do not use the example IP address when installing your Ethernet
adapter. Always consult your network administrator before assigning
an IP address.
To download the IP address for Windows
1. Start a DOS window.
2. Type the following command:
arp -s nnn.nnn.n.nnn nn-nn-nn-nn-nn-nn
ping nnn.nnn.n.nnn
arp -d nnn.nnn.n.nnn
where:
nnn.nnn.n.nnn
nn-nn-nn-nn-nn-nn
is the IP address for the Ethernet
adapter
is the Ethernet address for the Ethernet
adapter
9
Advertisement
Table of Contents
