Table of Contents
Advertisement
Installation
8. Using screwdriver, remove two door plugs, and reinstall on
opposite side of door opening.
9. Reinstall four hinge attaching screws, removed in Step 1.
Wipe Out Inside of Dryer
Before using dryer for the first time, use an all-purpose clean-
er, or a detergent and water solution, and a damp cloth to re-
move shipping dust from inside dryer drum.
Figure 26
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
D317S_SVG
Figure 24
D606I_SVG
Figure 25
Plug In the Dryer
This appliance is to be supplied through a residual current device
(RCD) having a rated residual operating current not exceeding 30
mA.
The appliance must not be supplied through an ex-
ternal switching device, such as a timer, or connect-
ed to a circuit that is regularly switched on and off
by a utility.
Electric Dryer
Connect the dryer to an electrical power source. Refer to Electric
Dryer Only - Connect Electrical Plug for information on con-
necting power cord.
Connect to 30 Amp circuit.
1
Gas Dryers
Dryer requires 120 Volt, 60 Hertz electrical supply and comes
equipped with a 3-prong grounding plug. Refer to serial plate for
specific electrical requirements.
NOTE: The wiring diagram is located in the control
hood.
To reduce the risk of fire, electric shock, serious in-
jury or death, all wiring and grounding MUST con-
form with the latest edition of the National Electrical
Code, ANSI/NFPA 70, or the Canadian Electrical
Code, CSA C22.1, and such local regulations as
might apply. It is the customer's responsibility to
have the wiring and fuses installed by a qualified
electrician to make sure adequate electrical power is
available to the dryer.
When plugging in the dryer:
22
WARNING
2
3
4
D275I_SVG
Figure 27
WARNING
Part No. D518518ENR1
W943
W521
Advertisement
Table of Contents
