Using Static Wep Security - Intermec CN2G User Manual

Note: LEAP security is not supported with Microsoft security.
To enable LEAP security on your CN2G
Make sure you have configured the communications and
1
radio parameters on your CN2G.
Make sure you have selected Funk as your security choice.
2
From Intermec Settings, choose Communications > 802.11
3
Radio > Security Settings > Funk Security > Profile.
For Authentication, Select LEAP and then tap Save.
4
For Association, Select Open or Network EAP and then tap
5
Save.
For Encryption, Select WEP, and then tap Save.
6
Select User name, type your user name, and then tap Save.
7
Select Password prompt, choose Enter password now, and
8
then tap Save.
Note: You can use Prompt for password to troubleshoot
your connection to the network if you have problems.
Select User Password, type a user password, and then tap
9
Save.
Exit Intermec Settings.
10

Using Static WEP Security

The CN2G uses the Wired Equivalent Privacy (WEP) protocol
to add security to your wireless network based on the 802.11b
standard.
To use WEP security, you need:
• an access point with an 802.11b/g radio.
• a CN2G handheld computer with an 802.11b/g radio.
CN2G Handheld Computer User's Manual
Chapter 2 — Configuring the CN2G
45