Easymount EM-S880 Product Instruction Manual page 7

4. Lift the Roller up by turning the handle anti-clockwise, Feed the film directly over the top laminating roller and
through to the back of the system.
6. Cut through just the backing paper using the snitty [cutting tool] provided. Once cut, loosen the backing
all the way along the film, pull down from the middle and drape over the feed table.
5. Move towards the
5. Move towards the
rear of the system
rear of the system a
and pull the laminate
pull the laminate tight
tight from the middle
from the middle tow
towards you, while
the back of the syst
holding lower the
and lower the lamina
laminating roller by
roller by turning the
turning the handle
handle clockwise
clockwise. When the
anti - clockwise.
two rollers meet the
handle will go loose,
using one finger flick
the handle clockwise.
Using too much
pressure can cause a
wave in the middle of
the laminate.
6