Table of Contents
Advertisement
8.
Alter the speed to your preference
by turning the speed control knob.
During loading we advise a slow
Speed.
Switch the control panel to
Forward mode. [When not in use
w e advise you switch to off to
avoid accidental movement of
the rollers].
9. Press on the foot pedal to move the rollers forward, stop when the backing paper is towards the front of
the roller as shown in the below picture.
7. Apply tension to your laminate and waste backing
paper by turning the handles clockwise. If the film
looks creased or is not being drawn through the
rollers smoothly, apply more tension.
Laminate: This usually requires maximum
tension for 100 micron films.
Waste backing paper: This usually requires
only slight tension but can vary from
laminate to laminate Overtightening can
cause the laminate to move which can cause
creasing.
If you are using the Easymount
Sign single hot, you can select Hot
or cold. Heat can help soften the
Adhesive and reduce silvering.
Switch the control panel to foot
Switch the control panel to foot
pedal mode. [During operation
pedal mode It is advisable to start
this can be pressed to auto
.
mode and the machine will run
operation this can be pressed to
continually until the magic eye is
Auto mode and the machine will
interrupted or the forward and
run continually until the magic eye
is interrupted or the switch i s set
reverse switch is set to off].
to Off mode.
During
7
Advertisement
Table of Contents
