Easymount EM-S880 Product Instruction Manual page 11

4. Pull both the laminating film and media tightly together in the centre at the back of the system. Lower the
4. Pull both the laminating film and media tightly together at the back of the system in the middle. Lower the
laminating roller and check the media and laminate are tight against the rollers and are correctly aligned.
laminating roller using the roller Up/Down Switch. Check the media and the laminate are tight against the
If not raise the roller again, centralize the material and repeat steps above.
rollers, if not raise the upper roller again and repeat the above steps. Once finished Return the feed table to
its original position.
Once completed return the feed table to its home position.
5. Using the foot pedal, feed the media and laminate until the material reaches the take up unit at the rear of the
system. Pull from the middle and secure using tape. Once secured in the middle stick the left and right sides of
5. Using the foot pedal feed the media and laminate to the take up mandrel. Pull from the middle and secure
the material to the mandrel wherever they fall, do not pull as this can cause creasing.
using tape. Once secured in the middle stick the left and right sides of the media to the mandrel wherever
they fall [Do not pull the media].
Roll to Roll Finished
10