Table of Contents
Advertisement
Troubleshooting guide
If the media is buckling/bowing in the middle as shown in the below picture you have used too much roller pressure
and/or incorrect feeding:
Incorrect feeding:
•
Place both hands on the media and push corner to corner to ensure it is flat with no creases.
Place both hands in the center of the media and push towards the corners, this will flatten the vinyl.
Incorrect roller pressure:
Higher the laminating roller, pull the material from the middle at the rear of the
system and start to lower the roller slowly. Once to roller meet, the handle becomes
slack/loose. Using one finger, flick the handle in the downwards direction [clockwise].
The weight of the roller is adequate for laminating vinyl.
• Using the pneumatic pressure valve, pull the handle out towards you and turn the
pressure down [anti - clockwise]. Please note you can only have a pressure reading on the
gauge when the roller is in the down position.
11
Advertisement
Table of Contents
