Table of Contents
Advertisement
Operating system
This ProLiant server does not ship with provisioning media. Everything required to manage and install the system
software and firmware is preloaded on the server.
To operate properly, the server must have a supported operating system. Attempting to run an unsupported operating
system can cause serious and unpredictable results. For the latest information on operating system support, see the
Hewlett Packard Enterprise website.
Failure to observe UEFI requirements for ProLiant Gen10 servers can result in errors installing the operating system,
failure to recognize boot media, and other boot failures. For more information on these requirements, see the HPE UEFI
Requirements on the Hewlett Packard Enterprise website.
To install an operating system on the server, use one of the following methods:
•
Intelligent Provisioning—For single-server deployment, updating, and provisioning capabilities. For more information,
see Installing the operating system with Intelligent Provisioning.
•
Insight Control server provisioning—For multiserver remote OS deployment, use Insight Control server provisioning
for an automated solution. For more information, see the Insight Control documentation on the Hewlett Packard
Enterprise website.
For additional system software and firmware updates, download the Service Pack for ProLiant from the Hewlett Packard
Enterprise website. Software and firmware must be updated before using the server for the first time, unless any
installed software or components require an older version.
For more information, see Keeping the system current.
For more information on using these installation methods, see the Hewlett Packard Enterprise website.
Installing the operating system with Intelligent Provisioning
Procedure
1. Connect the Ethernet cable between the network connector on the server and a network jack.
2. Press the Power On/Standby button.
3. During server POST, press F10.
4. Complete the initial Preferences and Registration portion of Intelligent Provisioning.
5. At the Start screen, click Configure and Install.
6. To finish the installation, follow the onscreen prompts. An Internet connection is required to update the firmware and
systems software.
Selecting boot options in UEFI Boot Mode
On servers operating in UEFI Boot Mode, the boot controller and boot order are set automatically.
Procedure
1. Press the Power On/Standby button.
2. During the initial boot:
51
Setup
Advertisement
Table of Contents
