Hpe 1600 W Flex Slot Platinum Hot-Plug Low Halogen Power Supply - HP HPE ProLiant DX360 Gen10 User Manual

Table of Contents

WARNING: To reduce the risk of electric shock or energy hazards:

•

This equipment must be installed by trained service personnel.

•

Connect the equipment to a reliably grounded secondary circuit source. A secondary circuit has no direct

connection to a primary circuit and derives its power from a transformer, converter, or equivalent isolation

device.

•

The branch circuit overcurrent protection must be rated 27 A.

CAUTION: This equipment is designed to permit the connection of the earthed conductor of the DC supply circuit

to the earthing conductor at the equipment.

If this connection is made, all of the following must be met:

•

This equipment must be connected directly to the DC supply system earthing electrode conductor or to a

bonding jumper from an earthing terminal bar or bus to which the DC supply system earthing electrode

conductor is connected.

•

This equipment must be located in the same immediate area (such as adjacent cabinets) as any other

equipment that has a connection between the earthed conductor of the same DC supply circuit and the earthing

conductor, and also the point of earthing of the DC system. The DC system must be earthed elsewhere.

•

The DC supply source is to be located within the same premises as the equipment.

•

Switching or disconnecting devices must not be in the earthed circuit conductor between the DC source and the

point of connection of the earthing electrode conductor.