Table of Contents
Advertisement
Description
NIC LEDs
Power supply
LEDs
PCI riser LED
Over temp LED
Amp Status LED
Power cap LED
For more information, see "Systems Insight Display LED combinations (on page 11)."
Systems Insight Display LED combinations
When the health LED on the front panel illuminates either amber or red, the server is experiencing a
health event. Combinations of illuminated Systems Insight Display LEDs, the system power LED, and the
health LED indicate system status.
Systems Insight
Display LED and
color
Processor (amber)
Processor (amber)
DIMM (amber)
DIMM (amber)
Over temp (amber)
Over temp (amber)
PCI riser (amber)
Fan (amber)
Fan (amber)
Power supply (amber)
Status
Off = No link to network
Solid green = Network link
Flashing green = Network link with activity
If power is off, the front panel LED is not active. For status, see
"Rear panel LEDS and buttons (on page 13)."
Off = Normal
Solid amber = Power subsystem degraded, power
supply failure, or input power lost.
Off = Normal
Amber = Incorrectly installed PCI riser cage
Off = Normal
Amber = High system temperature detected
Off = AMP modes disabled
Solid green = AMP mode enabled
Solid amber = Failover
Flashing amber = Invalid configuration
Off = System is in standby, or no cap is set.
Solid green = Power cap applied
Health LED
System power
LED
Red
Amber
Amber
Green
Red
Green
Amber
Green
Amber
Green
Red
Amber
Red
Green
Amber
Green
Red
Green
Red
Amber
Status
One or more of the following conditions may
exist:
•
Processor in socket X has failed.
•
Processor X is not installed in the
socket.
•
Processor X is unsupported.
•
ROM detects a failed processor during
POST.
Processor in socket X is in a pre-failure
condition.
One or more DIMMs have failed.
DIMM in slot X is in a pre-failure condition.
The Health Driver has detected a cautionary
temperature level.
The server has detected a hardware critical
temperature level.
The PCI riser cage is not seated properly.
One fan has failed or has been removed.
Two or more fans have failed or been
removed.
One or more of the following conditions may
exist:
•
Only one power supply is installed and
Component identification 11
Advertisement
Table of Contents
