Ending A Connection; Connecting Directly To An E-Mail Server - Intermec 700 Series 700 User Manual

Ending a Connection

Connecting Directly to an E-mail Server

700 Series Monochrome Mobile Computer User's Manual
6 Do the following to synchronize your 700 Series Computer:
a Tap Start → ActiveSync to access the Microsoft ActiveSync applica-
tion.
b Tap Tools → Options. → the PC tab, check Include PC when syn-
chronizing remotely and connect to, then select your computer's
name from the drop-down list
Remote synchronization with a desktop computer will work only if a
partnership is set up with that computer through ActiveSync and Acti-
veSync is set to allow remote connections. Other restrictions apply. For
more information, see ActiveSync Help on the desktop computer.
To start the connection, simply start using one of the programs listed in
the preceding section. Once connected, you can perform the same activi-
ties as listed in the preceding section.
To disconnect, do one of the following:
S When connected via dial-up or VPN, tap the Connection icon (shown
left) on your navigation bar, and then tap End.
S When connected via cable or cradle, detach your 700 Series Computer
from the cable or cradle.
S When connected via Infrared, move the 700 Series Computer away
from the PC.
S When connected via a network (Ethernet) card, remove the card from
your 700 Series Computer.
You can set up a connection to an e-mail server so that you can send and
receive e-mail messages by using a modem or network connection and In-
box on your 700 Series Computer.
Note: The ISP or network must use a POP3 or IMAP4 e-mail server and
an SMTP gateway.
You can use multiple e-mail services to receive your messages. For each
e-mail service you intend to use, first set up and name the e-mail service. If
you use the same service to connect to different mailboxes, set up and
name each mailbox connection.
—
Chapter 2 Pocket PC 2002
85