Table of Contents
Advertisement
To deactivate the Bridge function touch . The
indicator will go off. The cooking zones will then operate
independently.
Fast heat up function
You can get a required heat setting in a shorter time if
you activate the Fast Heat Up function. This will run the
cooking zone at maximum until the required heat setting
is reached.
To start the Fast Heat Up function for a cooking zone:
1
Touch the power function sensor
2
Immediately touch your required heat setting.
After 3 seconds
comes on in the display.
3
The zone will heat at maximum until your required
heat setting is reached. The display will then change
from
back to the required heat setting.
4
To stop the Fast Heat Up function change the
heat setting.
Power management
Power management divides the power between the
front and rear zones for each of the 2 outer modules.
See illustration below:
This allows either the front or rear zone to draw power
from the other, if maximum power is required.
The timer
The count down timer
Use the count down timer to set how long you want a
cooking zone to operate.
IMPORTANT!
•
To select the cooking zone: touch the sensor
and again until the correct zone indicator is displayed.
•
Immediately, touch the
99 minutes). When the timer indicator of the cooking
zone starts to flash more slowly the time will begin to
count down.
•
To see the remaining time select the cooking
zone with the
sensor. The display will show the
remaining time.
•
To change the count down timer: select the cooking
zone with the
sensor and touch
•
To deactivate the count down timer select the cooking
zone with the
sensor and touch
(
will come on).
again
sensor to set the time (00 -
or
.
until the time
counts down to 00. The timer indicator will go out.
When the timer count down comes to an end, the cooking
zone will deactivate, the 00 will flash and a beep sound
will occur for 20 seconds.
The beep sound and flashing can be deactivated
immediately by touching the
When the two timer functions operate at the same time,
the display shows the count up timer first.
The Minute minder
You can use the timer as a minute minder when the
cooking zones are not in operation. Touch
touch
or
of the timer to set the time. When the timer
countdown comes to an end, 00 will flash and a beep
sound will occur for 30 seconds. The beep sound and
flashing can be deactivated immediately by touching the
sensor.
The Pause function
Use the
function to close down all of your operating
cooking zones to the lowest heat setting with just one
touch.
•
To activate this function touch . The indicator
will come on and the symbol
operating zones.
•
When
is activated, you cannot change the heat
setting.
•
To deactivate this function touch
setting that you set before comes back on.
Deactivating the beep sound
The beeping sound can be deactivated if required.
•
First deactivate the hob.
•
Then hold down
for 3 seconds. The displays will
come on and then go out. Then hold down
seconds. 60 will now be displayed.
•
Touch
and change display to 61. The sound will
now be off.
•
When the sound is deactivated you will still hear
sounds when:
5
You touch
.
6
You put something on the control panel.
7
The timer alert comes on.
To reactivate the sound
•
First deactivate the hob.
•
Then hold down
for 3 seconds. The displays will
come on and then go out. Then hold down
seconds. 61 will now be displayed.
•
Touch
and change display to 60. The sound will
now be on.
sensor.
IMPORTANT!
. Then
will show on all
again. The heat
for 3
for 3
51
Advertisement
Table of Contents
Troubleshooting
