Electrolux EVE915 Installation & User Manual page 50

50 electrolux.com.au
USING THE INDUCTION HOB
Display
4
4
4
4
4
4
4
4
4
4
WARNING!
Risk of burns from residual heat!
The residual heat display indicates how much
heat is left on the ceramic glass when the zone is
deactivated. Use this display to help avoid the risk
of burns.
Activation and deactivation
Touch for 1 second to activate or deactivate the
appliance.
NOTE: When using cookware greater than 220mm the
manufacturer recommends that the centre zone be used.
Automatic switch off
THE APPLIANCE WILL AUTOMATICALLY SWITCH OFF IF:
• All cooking zones are deactivated (
• You do not set the heat setting after you activate the
appliance.
• You spill something or put something on the control
panel for more than 10 seconds (a pan, a cloth, etc).
An acoustic signal will sound and the appliance will
switch off. Remove the object or clean the control panel.
• The appliance becomes too hot (eg. when a
saucepan boils dry). Before you use the appliance
again, wait for the cooking zone to cool down.
• You use incorrect cookware. The symbol
come on and the cooking zone will deactivate
automatically after 2 minutes.
• A cooking zone is on for an extreme length of time.
The symbol will show and the appliance will switch
off. See below.
• The length of time that various settings can run
for before automatic switch off occurs are
shown below:
(CONTINUED)
Function
Indicates the cooking zone is deactivated.
Indicates the cooking zone is operated.
Indicates the function is operated.
Indicates the Automatic Heat Up function is operated.
Indicates the Power function is operated.
Indicates there is a malfunction (refer to malfunction list).
Indicates how much residual heat is left on a zone.
Indicates the Child Safety Lock is operated.
Indicates the use of incorrect cookware, too small or no cookware on the
cooking zone.
Indicates the Automatic Switch Off function has operated.
•
•
•
•
The heat setting
To adjust the heat setting, place your finger over the heat
bar graphic and slide across. The display will show the
adjusted heat setting.
).
NOTE: When you use cookware larger than 180mm the
manufacturer recommends that you put it on the rear
cooking zones.
Bridge function
will
The Bridge function connects two cooking zones together
and then operates them as one. You can use this function
for cookware larger than 260mm.
First set the heat setting for one of the cooking zones.
To activate the Bridge function touch . The indicator will
then come on. To set or change the heat setting, touch
either one of the control sensors.
- 6 hours
- 5 hours
- 4 hours
- 1.5 hours