Physiomed PHYSIOTHERM-S Operating Instructions Manual page 22

Short Wave Therapy
(2) Check the parameters for compliance with the desired type of therapy.
(3) Select the output power parameter with the data selector <3>.
(4) By turning the data selector <3>, slowly increase the output power. Observe
the matching display and the well-being of the patient (verbal response).
(5) Adjust the parameter setting during the treatment, if necessary.
During active treatment it is not possible to switch directly from
Note
continuous mode (CW mode) to pulsed mode and vice versa.
(6) Press the stop button <4> to interrupt the treatment or wait until the
treatment duration has elapsed (signal tone).
(7) Remove the electrodes and ask the patient how he feels.
14 PHYSIOTHERM-S