Table of Contents
Advertisement
3.4 Unpacking the unit
The unit is generally delivered with the packaging material supplied by the
manufacturer. Since the unit weight is about 60 kg, it must be unpacked by at least
2 persons!
Proceed as follows:
(1) Position the transport packaging so that the UP mark is pointing upward.
(2) Remove the safety bands from the transport packaging.
(3) Remove the transport packaging upward.
(4) Remove the remaining foam material.
(5) Lift (at least two persons) the unit from the lower packaging element.
3.5 Inspection upon receipt
Immediately after unpacking the unit you should:
(1) Verify the delivery documents to make sure that the delivery is complete.
(2) Check the external components and accessories for possible damage due to
transport.
Warning
In case of damage from transport that could endanger personal
safety, the unit must not be connected to the power supply!
3.6 Damages
Claims for damages resulting from damage due to transport are valid only if the
carrier and the manufacturer are notified without delay. The remedy of damages is
generally carried out by the manufacturer (refer to
page 49).
Prepare a damage report at once and send it to the carrier and to the dealer.
When returning the unit, include the following information:
•
Name and address of the sender and receiver
•
Type and serial number of the unit
•
Description of the defect (damage report)
•
Date and signature
PHYSIOTHERM-S
Service, Repairs, Maintenance
Installation
on
7
Advertisement
Table of Contents
