Resetting; Figure 1-5 Resetting Your Computer - Intermec 600 Series 600 User Manual

General Information
"
"
"
"

Resetting

In the rare event that your Industrial Mobile Computer
fails to respond to your input, it may be necessary to
"reset." To reset press the [Gold], [Esc], and [0] keys at the
same time, hold the keys down for three seconds, and your
computer will reboot. Resetting takes you to the start up
screen.
Reset keys
1-10 600 Series Industrial Mobile Computer User's Guide
A serial cable plugs into and latches to the docking
connector and provides a standard PC compatible
DB-9 (male) serial port.
A data sychronous cable plugs into and latches to the
docking connector and provides a DB-9 (female) which
can be plugged into a standard PC serial port.
The 600 Series Single/Vehicle Dock provides a stan-
dard PC compatible DB-9 (male) serial port.
The 600 Series Multidock converts the signals from
the computer's RS-232 serial port to RS-485 and
brings out an RS-485 bus to two DB-9 female connec-
tors compatible with Norand RS-485 networking.
Figure 1-5
Resetting your Computer
SECTION 1