Panning - Intermec 600 Series 600 User Manual

SECTION 2
3. Windows prompts you to accept the license agreement.
4. Key in the WIN 95 product ID number from the Cer-
5. The Certificate of Authenticity number comes with
6. Windows may prompt you to update the clock. Tap in
7. You will probably be asked to enter your username
8. When the Pen Alignment Program comes up, tap
" NOTE:
Pen Alignment is how close to the arrow on the display that you
must place your stylus to make the entry or selection.
9. At the Finetune Calibration screen, either tap Save

Panning

Panning is moving around within the display area to view
data. The program or application on your hand-held
computer was designed on a full size pc display area. To see
all that data you must move around on that larger area
with your smaller display.
Remember these suggestions. First, the cursor will return
to the upper left-corner of the display. Second, to keep from
getting lost, put your stylus in the middle of the display
area and drag it to the right, left, upper, or lower edge.
Dragging it in this method takes you to the outer parameter
of the display. This shows you where you are on the display.
Either Tab over, or tap on the I accept the agree-
ment choice and then Next.
tificate of Authenticity document.
your Windows 95 card. Tap on End or press ENTER.
the correct time and date and press ENTER.
and password.
on each of the four crosshairs three times. You have 30
seconds to complete the series of three taps (plenty of
time!) in each corner.
or make the adjustments you want.
600 Series Industrial Mobile Computer User's Guide
Operation
2-9