Table of Contents
Advertisement
SEATPOST ASSEMBLY & INSTALLATION
1. Apply a light coat of carbon assembly
compound to the upper face of the
Seatpost, making sure to cover area
around the adjustment slots.
2. Locate saddle rail between Crossbars
and Saddle Clamp Base, and place on
Seatpost.
3. With alignment washers installed,
attach assembly to Seatpost, by
tightening lightly greased fixing
screws, alternating between the two
sides each 1/2 turn. Once saddle is
adjusted, tighten fixing screws to a
maximum of 8Nm.
Accessory Mount
Kit-Rear
MT-LM-R-003
Torque fixing
screws to 2.5Nm.
Replace rear upper
clamp with Accessory
Mount kit version.
Tighten to maximum
Alignment
8Nm.
Washers &
Fixing Screws
19
Crossbars
The R5-CX uses a proprietary
Saddle
shaped seatpost. Do not
Clamp
attempt to use any seatpost
Base
other than the model provided
by Cervélo.
SP-SP24-15MM
SP-SP24-ZERO
DI2 BATTERY INSTALLATION
The battery for your Shimano Di2 system mounts inside the
seat tube using the Seatpost Internal Battery Mount (MT-BINT-SP2).
As this is an enclosed location, it is important to test the system
prior to final installation.
Press the Di2 battery
into the Seatpost
Internal Battery Mount
(MT-BINT-SP2) and
attach the E-wires
according to manufacturer
instructions.
Insert the assembled
battery and holder into
the seatpost.
20
Advertisement
Table of Contents
