Control Techniques M'Ax 403 User Manual page 41

Is an external braking resistor
used?
Does the Drive require de-rating?
Initiate saving the new values by
setting parameter
After changing the setting and
while the display is in Edit mode,
press at the same time:
To use the saved values after the
next power-up, ensure parameter
0.50 is set at
Close the Hardware enable
contact and ensure parameter
6.15 Drive enable
Display shows
The next step will start
the motor running
Close the RUN
Display shows
is being driven?
When the motor speed is constant,
check that the values of parameters
0.04 and 0.05
Basic setting-up is completed.
See Optional setting-up
this chapter.
M'Ax User Guide
Issue Number: 4
1
NO
2
NO
3
XX.00 at 1000 .
4
and
5
no .
6
at . 1
StP .
7
contact.
8
run and the motor
9
YES
10
are the same.
later in
YES
Set parameter 10.55 Internal
braking resistor protection disable
at . 1
YES
See Planning the installation in
Chapter 2 of the Installation Guide.
After changing the setting and
while the display is in Edit mode,
press at the same time:
and
Open the RUN contact, then see
Appendix B Diagnostics .
Display shows TrP ; motor is
stopped
NO
If the mechanical resonances occur
when the motor is running, see
Testing the system in
stiffness and load inertia
Optimising the Dynamic Performance.
*
Specifying shaft
in Appendix D
35