Setup and operate the GK7000 / GK7600
S Control settings:
adjust alarm and range window and start/ stop/ end Conditions,
datareduction, measuringtime
Refresh curve mode:
- "Dynamic" permanent indication during the process
- "On process ready" indication of the curve after the process in ready
S Data storage:
configure datastorage mode of the MP85, the target for datastorage:
Options with "external" storage target:
- Flashdisk in the folder „Flash disc 1"
- Additional USBstick (selection via
- Networkpath (if GK7000 / GK7600 and MP85 are running in a Ether
netnetwork) or if MP85 is equipped with a memory card
- SD card in MP85
S Limit values:
Adjust und parameterization limit switches of the MP85 and display of their
relevant states.
S InputsOutputs:
adjust the functions of the digital IN and Outputs of the MP85 and display
their status
S Parameter Set:
Load/ save parametersets and factory settings to the flash (internal MP85
memory)
or MMC/SDcard memory of the MP85
or on the GK7000 / GK7600 as backup
S Change passcode:
change the adminpassword (standard is "1111")
28
A03435_01_Y00_01 HBM: public
, is displayed as „Hard Disk")
GK7000 / GK7600