Emi And Flush Strike (Optional) - Harmar Mobility CPLP400 Installation And Owner's Manual

14
EMI and Flush Strike Interlocks (optional)
The optional EMI or Flush Strike Interlocks are provided
with a combination mechanical lock and electric
contact. They are to be used with existing doors.
The interlock:
• Prevents the lift from running if the door is not
closed.
• Prevents the door from being opened if the
platform is not at the landing.
A length of multi-conductor wire will need to be ran from
the bottom of the lift tower to each interlock. Consult
local codes for type and mounting requirements. After
wiring is completed, the wiring harness must be
plugged into it appropriate receptacle on the controller
(ref pg 5).
Flush Strike Interlock
Refer to the instructions inside the strike box for
mounting requirements.
Flush Strike Interlock Wiring Connections
For AC powered lifts
Flush Strike Wires Rectifier Wires
Black‐White Stripe
Black‐White Stripe
Yellow
Yellow
Yellow
Blue
Grey
Green
Red
Black
Yellow
For Optional DC powered lifts
Flush Strike Wires
Black‐White Stripe
Black‐White Stripe
Yellow
Blue
Grey
Green
Red
Black
* This is a single wire that will have 2 wires connected to it.
Lift Harness Wires
Red
Black
Black
Green*
White
Orange
Blue
Red
Brown
Black
Red
Yellow
Green*
Lift Harness Wires
Black
Green*
White
Orange
Blue
Brown
Red
Green*
EMI Interlock
1) Position interlock to door jamb and mark
mounting holes.
2) Fasten Interlock to door jamb with #8 wood
screws.
3) Route 4-conductor Interlock cable thru hole in
top of interlock and make wire connections.
4) Attach door keeper and emergency key plates
to hoistway door.
EMI Interlock Wiring Connections
EMI
Black (A)
Black (B)
Yellow (C)
Yellow (D)
N/A
N/A
N/A
+ Must be tied together when using an EMI Interlock.
Lift Harness
Black
Green
White
Orange
Blue+
Brown+
Red