Temperature; Print - IEMAI MAGIC-HT-M Operating Instructions Manual

7.2 Temperature

Problem one: click on the heating, the temperature
does not change, a few seconds later prompted the
heating power is insufficient, check the heating
head temperature rise
Attention: temperature measurement careful of
high temperature hot hands
Problem 2: Temperature display "1023"

7.3 Print

Problem 1: Prompt 1 extruder no material, cannot
print properly
Problem 2: The print appears to be detached
from the bottom and is carried away
Problem 3: Use of automatic unload filament, but
stuck between extrusion gear and extrusion clamp
Problem
Problem
Whether the print head is installed, or whether the
wire is connected
Print head is not properly installed
Add filament at the break detection
After determining that the platform is able to
print that material, adjust the platform and
nozzle gap when the zero point is small
Printing - Installing the Build Platform and
Leveling for more
Remove the print head and cut off the deformation
part
32
Print More Materials, All For Application
Solution
Solution
information)
(see