Table of Contents
Advertisement
13.2
T
B
RAPEZE
AR WITH A
The trapeze bar is made of a steel thick-wall tube with a protective powder varnish. It is provided
with a locking pin (1) in the bottom section. The upper part contains the locking system of a small
bar. The bar is plastic with a textile strap of adjustable length. After removing all the packaging
parts, the trapeze bar with a small bar are ready to be placed on the bed:
Insert the bottom end of the trapeze bar (1) in the universal holders of accessories
•
in the bed corner
Rotate the trapeze bar so that its upper end points to the centre of the bed – in the
•
correct position, it is arrested (stops turning)
Insert the strap (3) loosely in the arresting lug (2) of the small bar (4)
•
•
Adjust the required height of the small bar using the clip (5) or the self-winding
mechanism
•
From your optimum position, you can rotate the trapeze bar by lifting and turning
it in the required direction
Once the trapeze bar is moved to the optimum position, it will lock again
•
automatically
Before using the trapeze bar, always make sure that it is properly arrested
•
Disassemble it by thrusting the bar from the holder in the bed frame corner upwards.
The maximum short-term load of the trapeze bar with the small bar is 75 kg. Overloading of the trapeze bar with the
small bar may result in its damage and permanent deformation!
Before using the trapeze bar, always make sure that it is properly arrested!
Under loading, the trapeze bar with the small bar sags due to strength and flexibility. The maximum load of the
trapeze bar with the small bar may result in hazardous reduction of the minimum distance between the trapeze bar
and the headboard. There is a risk of pinching in the place of the trapeze bar overloading! There is a risk of pinching
in the place of the trapeze bar overloading!
13.3
I
S
NFUSION
TAND
The infusion stand is supplied in a complete state and is ready for immediate use after removal of all parts of the packaging. After
unlocking the plastic arresting mechanism (1) in the upper part of the leg, the telescopic extension holder of infusion is released.
Grasp the top of the infusion stand (2)
•
Lift up the control lever (1) upwards
•
Extend or retract the telescopic section to the desired position
•
Secure the telescopic section by tilting the lever downwards
•
Check that the telescopic section is correctly fixed (insufficient securing could cause the infusion holder
•
to spontaneously slide into the holder leg causing unwanted bodily harm or damage to surrounding objects)
Tilt the hooks at the top of the infusion stand for the suspension of infusion bottles and medical bags
•
– maximum load per a hook is 3 kg.
The infusion stand for the bed is intended exclusively for hanging infusion bottles and medical bags!
Check that the telescopic section is correctly fixed. Insufficient securing could cause the infusion
holder to spontaneously slide into the holder leg causing unwanted bodily harm or damage to
surrounding objects!
This infusion stand is only intended for the beds made by PROMA REHA, s.r.o.! It is designed for
use in the interior and its maximum load is 12 kg, the maximum load per a hook is 3 kg!
Instructions for Use of VERTICO Bed
S
B
MALL
AR
Page 22/32
2
3
5
4
1
2
1
Advertisement
Table of Contents
